The G Pen Roam is powered on with five clicks of the circular activation button located above the G Logo on the rear of the unit. The Roam can be powered off with five clicks of that same button. The unit will vibrate to indicate it has been powered either on or off.
To load concentrates into the G Pen Roam, first flip the unit's lid upward to expose the quartz heating element underneath. Using the included tool, place concentrates onto the center of the enclosed quartz dish. Once the desired amount of concentrate is loaded, close the lid to cover the heating element. Press the power button two times to activate heating.
To fill the G Pen Roam's water tube, first remove the unit's battery and heating chamber by gently pulling up and away from the mouthpiece. The Roam's mouthpiece can then be removed from the enclosed water tube by gently pulling upward. Water can then be poured into the tube's opening until it reaches the black fill line at the bottom of the tube. Once the mouthpiece and battery is reattached, the Roam is ready for use.
TEMPERATURE
Once the G Pen Roam is powered on and the desired temperature is selected, click the main power button two times to activate heating. The Roam will vibrate, and its display will show wavy lines to indicate heating has begun. Once the unit reaches temperature, it will vibrate again and will display a thumbs up. Heating can be cancelled at any time during the process with two more clicks of the power button.
Once the G Pen Roam is powered on, the temperature setting can be adjusted in increments of 25* F using the two buttons on the side of the device. The temperature can be changed to *C by holding the power button and temperature increase button for three seconds.
The G Pen Roam tailors to each user’s flavor and heat preferences through a digital temperature control and LED display ranging from 600° - 800°+F (315° - 427°+C), along with a haptic feedback feature that indicates when the device is ready for use.
CLEANING TIPS
-
Separate the following components:
-
Quartz tank
-
Tank cover
-
Two detachable air path channels:
-
Stainless steel central air path channel inside flip-top lid of battery
-
Silicone air path channel liner attached to internal backing of battery
-
Excluding the silicone air path channel, soak the above parts in ISO for at least one hour, then remove and wipe down all surfaces with cotton swabs.
-
Use a cotton swab with ISO to clean off any reclaim in the silicone air path channel liner and battery, then wipe down and dry completely.
-
Common areas for clogging can be found in the stainless steel air path inside the flip-top lid of the battery, the air path opening at the bottom of the Quartz tank, and along the silicone air path liner of the battery. To minimize clogging in these areas, be sure to limit your loads to smaller dab sizes, no larger than a couple grains of rice.
-
Fully assemble parts and engage device at full activation on MAX temperature level to burn off any residual ISO on remaining parts.
